Fyola Facial Massager - Step by Step - Instructions

1. When To Apply Gel And When To Apply lotion or serum?

Ultrasound Mode
When using the ultrasound mode, apply a suitable amount of water soluble gel or lotion (a circle with 2 cm diameter) on the facial head or your skin. Gel is better, since it doesn’t dry up quickly on your skin and makes the facial machine device move smoothly over your skin.

But the main function of gel is to increases the conduction of ultrasound waves into your skin.
The gel prevents air from coming between the facial machine and the skin, therefore maximizes the transmission of the sound waves.

You can get ultrasound gel from a specialty store. Aloe Vera gel seems to have good results.

Galvanic mode

When using the ultrasound mode, apply lotion or facial serum with Vitamin rich C or Anti-Oxidant. The galvanic mode pushes the skin care ingredients into you skin. So make sure, the skin care product you have selected does NOT contain chemicals. You don’t want these chemicals get into your skin, right?

Even branded skin products might have chemicals. So make sure you check the ingredients before buying these product at your local beauty store. Select organic skin product with 100% natural ingredients.

Do NOT apply the ultrasound gel when using the galvanic mode. Some ultrasound gels might even contain chemicals or preservatives.

facial machine - ultrasound & galvanic treatment

2. Switch the power ON

Press on the power button to turn the Fyola on. The Fyola face massager send out a beep sound and some of the green or red light will turn on or flashing

3. Choose the Right mode

C: Cleansing (apply ultrasound gel)
M:Massaging (apply ultrasound gel)
N: Nutrition (apply quality lotion or serum, but Do NOT apply ultrasound gel)
L :Lifting (apply quality lotion or serum, but Do NOT apply ultrasound gel)

Optional Modes
W: Whitening (apply whitening lotion or serum, but Do NOT apply ultrasound ge)
W: Wrinkle Care (apply anti-aging lotion or serum, but Do NOT apply ultrasound ge)

You can use the two basic steps (good for acne skin) in a row:

1. Cleansing (4 minutes)

2. Massaging (4 minutes)

Total basic treatment is only 8 minutes.

A. Apply gel –> Choose Cleansing Mode –> Select Ultrasound mode –> Gently rub your whole face for 4 minutes –> Wash your face with warm wet towel

B. Apply gel –> Choose Massaging Mode –> Select Ultrasound mode –> Gently rub your whole face for 4 minutes –> Wash your face with warm wet towel

C. Done

4 Ultrasonic, Galvanic Ion or Both?

For massage and cleansing mode select ultrasonic wave mode only. This will remove waste inside your skin. Especially good for acne or oily skin.

When choosing lifting, nutrition, whitening or wrinkle care mode choose galvanic ion mode to enhance the absorption of cosmetic ingredients (Vitamin C) into your skin. For best results select both the ulrasound and ion mode. When both the ultrasonic and galvanic ion mode are used at the same time, the permission through the out skin layer will be 77 times better than using the ultrasonic mode or galvanic mode separately.

5. Move the facial head around your face
Move the treatment head of the facial massager in circle following the formation of the muscles. See illustrations for the directions. Do not stop moving the treatment head in use, about the rate of 5 centimeters within 1 second. The power will shut off automatically.